View Full Version : oil level gauge
Hi all, just got a williams 2, and the oil level gauge does not work, any one got any ideas????(apart from use the dip stick) thanks for any help. :D :lol:
lewis_willy2
06-10-2006, 19:08
dnt shout at me incase you know but the oil level dont work when the engines running.
oh and welcome 2 willy ownership. i got a willy 2 on tuesday :D
dnt shout at me incase you know but the oil level dont work when the engines running.
oh and welcome 2 willy ownership. i got a willy 2 on tuesday :D
This one dont work at all mate :o
the oil level will only work for about 10/15 seconds after ignition. and then the needle will drop.
does the oil temp gauge work? They share a sender you see.
Rudders16v
10-10-2006, 08:52
Yeah the oil temp and oil pressure gauges both worked. The oil level gauge was dead though, didn't even flicker on start up
i have this on my racing car mate.
Apparently i need to check to see if the sender from a known good car works the dial in mine....as the sender does both jobs. So one side of it could be broken.
In my case the oil temp works but the level doesnt. A new sensor will be a good starting point.
Check that your connector is fully clipped together. You should be able to see it near the idle control valve (or follow the wiring up from around the area where the dipstick goes into the block)
should be picking the car up tommorrow night, so will have a look then, thanks for the help :D :D :D
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.