Straight through section...where from?

[freebone16v]

i am looking at getting a straight through centre section for my exhaust now as apose to my magnex at the moment.....any ideas where i can get them from people?

cheers neil

[Matt_16v]

i can do one for you.

[big hp]

Your best bet would be powerflow.

[freebone16v]

interested matt......tell me more

powerflow wanted 160 just for the centre section...i thought that was a bit steep really

[Matt_16v]

that doesnt seem too bad really, is that with new a new flange??

If you wanted a complete centre section then i could probs do it for around £80 providing i can get materials from work.

However, on my exhaust, i have a scorpian, i jus took the centre box out n welded in a straight pipe, but purged the pipe when i welded it to ensure a nice weld on the inside aswell as the outside. works just as wel in my opinion

cheers

matt

[freebone16v]

i would be interested in the centre section at that price mate....

i will also look into the idea of welding in a piece of pipe..sounds a bit of a bodge though on a perfectly good section

[Winston]

Powerflow made me one for £60 ....using my old system

[freebone16v]

may have to look into that to then mr winstonian

[Matty86]

i did the same as the other matt, cut out the silencer and put a long bit of pipe there instead (took out the cat at the same time :p). cost me £20.

[freebone16v]

think i may speak to someone about doing that then maybe

[Andy P]

Think you will see much gain though mate?

May loose some torque, valvers need all they can get :wink:

[Amirclio]

Powerflow charged me £40 for my center section, i only did it cause the baffles went and it sounded shocking!

[Matt_16v]

i think i did lose some power on my valver, in the low range, but it sounds awesome!!