View Full Version : Straight through section...where from?
freebone16v
05-10-2006, 15:45
i am looking at getting a straight through centre section for my exhaust now as apose to my magnex at the moment.....any ideas where i can get them from people?
cheers neil
Matt_16v
05-10-2006, 15:54
i can do one for you.
Your best bet would be powerflow.
freebone16v
05-10-2006, 16:10
interested matt......tell me more
powerflow wanted 160 just for the centre section...i thought that was a bit steep really
Matt_16v
05-10-2006, 16:29
that doesnt seem too bad really, is that with new a new flange??
If you wanted a complete centre section then i could probs do it for around £80 providing i can get materials from work.
However, on my exhaust, i have a scorpian, i jus took the centre box out n welded in a straight pipe, but purged the pipe when i welded it to ensure a nice weld on the inside aswell as the outside. works just as wel in my opinion
cheers
matt
freebone16v
05-10-2006, 17:10
i would be interested in the centre section at that price mate....
i will also look into the idea of welding in a piece of pipe..sounds a bit of a bodge though on a perfectly good section
Powerflow made me one for £60 ....using my old system
freebone16v
05-10-2006, 18:28
may have to look into that to then mr winstonian
i did the same as the other matt, cut out the silencer and put a long bit of pipe there instead (took out the cat at the same time :p). cost me £20.
freebone16v
05-10-2006, 20:08
think i may speak to someone about doing that then maybe
Think you will see much gain though mate?
May loose some torque, valvers need all they can get :wink:
Amirclio
05-10-2006, 21:53
Powerflow charged me £40 for my center section, i only did it cause the baffles went and it sounded shocking!
Matt_16v
06-10-2006, 09:12
i think i did lose some power on my valver, in the low range, but it sounds awesome!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.