PDA

View Full Version : Only 1 brake pad worn?? :S



BristolSam16v
28-09-2006, 12:24
On my drivers side the pad on the outward face of the disc is down to the metal, but on the backside of the disc that pad has 5mm left! Pads were new when put on and the passengers side is fine... whats going on??

pat_986
28-09-2006, 12:38
Its probiably your slider's that are stuck, Give em a overhaull.

BristolSam16v
28-09-2006, 13:07
Easier to get a 2nd hand caliper or no?

pat_986
28-09-2006, 13:31
If its only the sliders that need doing, then no, I would just do that myself.

Either but the kit from Renault, new slider bars, grease (spelling) dust covers and bolts, or just clean up what you have.

If the caliper needs replacing, I would buy new (I have just done this)
But note that most places only sell the pistion part of the calliper and not the carrier/slider part.

BristolSam16v
28-09-2006, 13:41
Ok cheers for the advice! any guides on how to clean out the calipers etc? Im sure I've seen one floating around somewhere...

clowo16v
28-09-2006, 18:37
I posted one but I think it was lost.

You need to hit the sliding part of the caliper with a hammer to get it moving. Once its moving ok you can then remove the caliper and separate the 2 halves completely. You then need to wire brush or lightly sand with 1200 grit sandpaper the sliding pins and clean the holes where they are. Re-grease them with red rubber grease and put em back together.

Matt