View Full Version : Quick question about lowering a torsion bar
NaplesValver
17-05-2006, 12:11
Ive got this guide printed out:
http://www.zedsplace.co.uk/e107_plugins/content/content.php?content.9
but would like to know what size socket, bolt and nut i use to make the tool???
cheers
-->NV
donsrno1
17-05-2006, 12:18
bolt and nut are M10 and socet is 32mm IIRC. Probably best to wait for these to be confirmed though. You can use a few different sized sockets but I think 32mm is OK.
jwarren2k2
17-05-2006, 12:22
yeah thats right^^^
M10 thread with 32mm socket! :D
NaplesValver
17-05-2006, 12:24
Cheers guys, just what i was after.
just need the valver now
Also, what drive does the socket need to be, or does it not matter??
-->NV
donsrno1
17-05-2006, 19:12
the drive won't matter as long as theres enough room to get the bolt through. I would think most 32mm ones will be 1/2 inch anyway. I've never checked if there would be enough room in a 3/8 drive socket for the nut.
only just fits in a 1/2drive socket, as above, never seen a 3/8" drive 32mm socket
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.