PDA

View Full Version : Tuned Williams engine, with box and loom



case
15-05-2006, 19:11
Engine had 80 000 miles on it before being rebuilt. Rebuild included:

Journal Grind,
Bottom end bearings,
Complete refurd of head including new stem seals etc,
Piper cams,
Piper vernier pullies,
New cam belt,
Engine balance,
Lightened and faced flywheel,
Piper valve lifters,
Piston rings,
Complete head gasket kit,
Conversion set (Crank seals),
Upper cam tensioner,
Lower cam tensioner,
New oil filter,
New spark plugs,
Distributor and rotor arm set,
HT lead set,
Head bolt set,
Head set (F7P)
Group A clutch,

Since this work the engine has covered around 5,000 miles and has had 3 oil changes in this time. Always run on silcolene 15W40.

The box is nice and tight. I bought it second hand but was told then it had recently been reconditioned so to the best of my knowledge it has covered around 10,000 miles.

This sale also includes a complete williams loom and ECU.

With the engine running cam's, pullies, lightened and balanced bottom end, it should run just under 170 bhp. With a re-map which would cost around £300 you should be able to get about 180bhp out of it.

I also have a valver manifold and new exhaust gasket for the engine but i only ever ran it with a willaims manifold.

I have spent over £2000 on parts and work on this engine and that’s with me rebuilding alot of it myself and that also doesn’t include the initial money spent buying the engine box and loom.

I'd like £1500 for this or nearest offer.

I'm in the midlands (Kidderminster) and for obvious reasons postage isn't really an option. Engine is currently in the car and it should be possible for the buyer to see it running before buying it.

Thanks
Mark

http://images.fotopic.net/y8mz3r.jpg
http://images.fotopic.net/ygxg2t.jpg