cliokongen
03-05-2006, 22:01
I needed a new driveshaft for my Valver.
I got the correct part no. 77 01 351 696 and here is the strange thing – it’s only 28mm diameter where the old one is 35mm diameter.
You guys have a good explanation for that?
Better steel – less material?
I've noticed that the thick old one narrows in at both ends to approximately the same diameter (28mm) as the new one.
If it should break, did they plan for it to break in those spots?
Michael
http://www.renaultklubben.dk/forum/forums/thread-view.asp?tid=1641&start=1
I got the correct part no. 77 01 351 696 and here is the strange thing – it’s only 28mm diameter where the old one is 35mm diameter.
You guys have a good explanation for that?
Better steel – less material?
I've noticed that the thick old one narrows in at both ends to approximately the same diameter (28mm) as the new one.
If it should break, did they plan for it to break in those spots?
Michael
http://www.renaultklubben.dk/forum/forums/thread-view.asp?tid=1641&start=1