View Full Version : Camber Bolts

04-04-2006, 10:42

i'm away to lower my car again this weekend and a bit bothered about tyre wear due to the amount of camber its running atm and and by how much it will increase. This being the case, i'm considering whacking on some of these camber bolts but can someone explain how they work?

Also, the k-tec site (which sells them in 2's) states that they will offer
up to 3 degrees of adjustment - is that using one camber bolt per side? i.e would i get 6 degrees of adjustment using 4?



04-04-2006, 22:28
fit one bolt in the top strut bolt hole then by rotating the bolt by the head you can change the camber . you need a camber gauge to set it up. borrow one. when adjusted right hold the head without moving it and tighten the nut to the spec torque setting.

04-04-2006, 23:10
u only need 2 bolts, just as maxiboy says fit them to top holes and adjust

05-04-2006, 09:13
Got it...cheers folks! :)