View Full Version : Removing Handbrake cable from caliper
Now this won't budge and can't fit new caliper until I have this out....
Any suggestions?
As fitting new calipers may just chop the cable off and fit new cable with new caliper.
Big screwdriver and a big hammer and hit it hard, lots of times
i had same problem with mine, was seized solid and just wouldnt budge, so bought 2 new cables and chopped them out
mine had to be cut off aswell when i had new rear calipers last week
Gonna order new cables today. Might as well as £6.50 from GSF and just snip them.
Even if you cut them you still have the get the outer out somehow, just plenty of hitting, it will bidge, use a lump hammer
Its the end that's attache dto teh caliper I can't budge. As Caliper is being repalced not a problem as will just remove old cable from its routing and replace with new attching to new caliper.
Even if you cut them you still have the get the outer out somehow, just plenty of hitting, it will bidge, use a lump hammer
hes using a new caliper it dont matter lol
Oh, missed that bit :oops:
Still believe in doing things properly :lol:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.